Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Installation
- Introduction - Installation
- Main components for installation
- General preparations
- Before the installation of the wires
- Installation of the product
- To put the wire into position with stakes
- To bury the boundary wire or the guide wire
- To extend the boundary wire or the guide wire
- After the installation of the product
- Automower® Connect
- Settings in Automower® Connect
- Operation
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Warranty
- EC Declaration of Conformity
6.5 LED indicator lamp on the product
There is a LED indicator lamp on top of the product, which shows the current status:
Light Cause Action
Green solid light
The product is either mowing the lawn,
or leaving the charging station.
No action required.
Blue solid light
The product is either paused, parked,
charging or is searching for the charg-
ing station.
No action required.
Yellow solid light
The STOP button has been pressed. Press the START button on top of the
product to start it again.
Red solid light
The product has stopped due to an er-
ror.
Clear the error by pressing the STOP
button, and then activate the product by
pressing the START button on top of
the product.
Yellow flashing
light
The product requests the PIN code. The PIN code needs to be confirmed in
the Automower
®
Connect app before
the product can be activated.
There is more help on www.husqvarna.com. If you still need help, please contact your local Husqvarna
representative.
48 - Troubleshooting 1439 - 002 -