Operators Manual

Table Of Contents
ASSEMBLY
12 – English
Assembling the handlebar and
throttle
Fit the handlebar in the handlebar clamp on the shaft
using four screws.
Fit the protective sleeve as shown in the diagram.
Fitting blades and trimmer heads
Fitting the guard extension
(543RS, 553RS)
CAUTION! The guard extension shall always be tted
when using the trimmer head/plastic blades and
combination guard. The guard extension shall always be
removed when using the grass blade and combination
guard.
Hook the blade guard/combination guard (A) onto the
tting on the shaft and secure with the bolt.
Enter the guard extension guide in the slot of the
combination guard. Then click the guard extension into
position on the guard with the four quick-fasteners.
!
WARNING!
When tting the cutting attachment it is
extremely important that the raised
section on the drive disc/support ange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is tted incorrectly it can
result in serious and/or fatal personal
injury.
!
WARNING! Never use a cutting
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is tted this can
cause serious personal injury.
IMPORTANT! If a saw blade or grass blade are to be
used the machine must be equipped with the correct
handlebar, blade guard and harness.
H1158941-30,533-553RS,WestII.fm Page 12 Tuesday, July 4, 2017 8:19 AM