Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Introduction
- To attach the throttle handle
- To assemble the handlebar
- To set the handlebar in transport position
- To assemble the cutting equipment
- To attach the grass blade guard/combination guard and the grass blade (555FX, 555FXT)
- To attach the saw blade guard (555FX, 555FXT)
- To attach the saw blade guard (555RXT, 555FRM)
- To attach the saw blade
- To attach the shredder blade guard and the shredder blade (555RXT, 555FRM)
- To attach the trimmer guard or combination guard for trimmer head and plastic blades
- To attach a trimmer head or plastic blade
- To adjust the Balance XT harness
- Operation
- Introduction
- To do before you operate the product
- Fuel
- Work position
- Correct balance of the product
- To start a cold engine
- To start a warm engine
- To stop the engine
- Heated handles (555FXT)
- Blade thrust
- General work instructions
- Forestry clearing with a saw blade
- Brush cutting with a saw blade
- Grass clearing with a grass blade
- Grass trimming with a trimmer head
- Shredding with a shredder blade
- Maintenance
- Introduction
- Maintenance schedule
- Carburetor
- To adjust the start throttle speed (555RXT, 555FRM)
- To clean the muffler
- To clean the cooling system
- Air filter
- Bevel gear
- Drive shaft
- To attach and remove the locknut
- To sharpen the grass knife and grass blade
- To sharpen the saw blade
- To examine the spark plug
- To adjust the product for cold environments
- To lubricate the wire (555FXT)
- Troubleshooting
- Transportation and storage
- Technical data
- Accessories
- EC Declaration of Conformity
a) Install the cover for the starter housing (C) and
the cover for the air filter holder (B).
b) Remove the air filter and the air filter cover.
Install the air filter (E) and air filter cover (A).
• In temperatures below -5°C/23°F, install the wear
guard with an air duct (D).
CAUTION: At temperatures of more than
-5°C/23°F or 0°C/32°F, remove the winter kit
from the product. There is a risk of engine
damages.
To lubricate the wire (555FXT)
Note: The wire is lubricated at the factory. Lubricate the
wire monthly.
1. Remove the protective cover.
2. Remove the cylinder cover to get access to the
rubber bellows on the wire.
3. Remove the plug on the grease nipple.
4. Use antifreeze spray with a 2 mm spray tube. Spray
in short intervals.
5. Examine the rubber bellows on the wire to make
sure that it does not expand.
6. Attach the cylinder cover and the protective cover.
1346 - 002 - 08.10.2019
29