Product Manual
BaggerMount
1. Install the bagger mount tube (A) to the rear
guardwith5/16-18x3-1/4boltsandange
nuts from kit.
2. Install the kit support straps (B) on the
outside of the mount tube. Attach the front
side of the strap to the fender support with a
5/16-18 x 1-1/4 bolt, inserting a spacer (C)
between the mower and the strap. Do not
addtheangenutatthistime.
3. Put the reinforcement plate (D) to the
outside of the fender support. Attach with an
additional 1-1/4 bolt and fasten both bolts
withangenuts.Repeatstepsonopposite
side.
NOTE: The front side of the kit support straps
should be on the inside of the mower frame.
4. Tighten all hardware.
A
B
B
C
D
MountingCoverAssembly
NOTE: Assistance from another person may
ease mounting the cover assembly to mower.
1. Lift and rotate the cover to align the cover
brackets with the support assembly tubes.
2. Move the cover down over the support tubes.
ContainerAssembly
1. Remove the end caps (E) from the center
two bag support arms.
2. Fully insert the spacer plugs (F) into the ends
of the support tubes. It may be necessary to
tap the spacers into place with a hammer or
mallet.
3. Replace the end cap back over the spacer.
The additional extension will hold the hood
more tightly when latched.
E
F
5
ASSEMBLY
5