Product Manual

MOUNTING COVER ASSEMBLY

TO SUPPORT ASSEMBLY

For ease of assembly, you may wish assistance from another

person for mounting the cover assembly to mower.

1. Position cover assembly on the ground behind the

mower.

2. Lift and rotate cover to align the frame bracket with the

hanger and slide the cover down until secure.

Remove plastic end cap from the center bag support arm.

Fully insert spacer plugs into the ends of the support tube. It

may be necessary to tap the spacer into place with a hammer

or mallet. Replace the plastic end cap back over the spacer.

The additional extension will hold the hood more securely

when latched.

INSTALLING SPACER PLUG

Frame

Bracket

Hanger

Remove center

end cap

Insert spacer and

replace cap

CONTAINER INSTALLATION

1. Install containers on support frame, overlapping

containers at center tube.

NOTE: One container should always overlap the other

container at the center tube.

2. Close cover and lock latch handle over support tubes.

Support Frame

Latch Handle

1. Raise and hold deﬂector shield in upright position.

2. Fit lower chute around the shield bracket.

3. With the lower chute in proper position, hold the chute

securely and hook the lower chute latches to the mower

deck.

NOTE: While hooking the latches, the deﬂector shield may

try to push the chute away from the mower deck opening. It

is important to hold the chute in position while hooking the

latches to the mower deck.

LOWER CHUTE INSTALLATION

assembly