Product Manual

10
5/16"
NYLOCK
NUTS (S)
5/16" x 1-3/4"
HEX BO L T S (G)
5/16"
NYLOCK
NUT (S)
DUMP
HANDLE
TUBE
DUMP PI V O T
BR A CKE T
FIGURE 14
DUMP HANDLE
TUBE EXTENSION
DUMP HANDLE TUBE
1/4" NYLOCK
NUT (U)
1/4" x 1-3/4"
HEX BOLT (I)
DUMP CABLE
USE THIS HOLE
FIGURE 15
STEP 15: INSTALL DUMP HANDLE TUBE
(SEE FIGURE 14)
• Install the dump handle tube to the dump pivot bracket
assembly using three 5/16" x 1-3/4" hex bolts (G) and
5/16" nylock nuts (S).
STEP 16: INSTALL DUMP HANDLE TUBE EXTENSION
(SEE FIGURE 15)
• Install the dump handle tube extension on the dump
handle tube using a 1/4" x 1-3/4" hex bolt (I) and 1/4"
nylock nut (U).
• Attach the dump cable to the dump handle tube using
three cable ties (OO).
LIFT HANDLE
TUBE EXTENSION
1/4" NYLOCK NUT (U)
1/4" x 1-3/4"
HEX BOLT (I)
LIFT HANDLE
TUBE
FIGURE 12
FIGURE 13
INDEX ROD
LIFT CABLE
CABLE
ADJUSTMENT
NUTS
HOOK
LIFT TRIGGER
STEP 13: INSTALL LIFT HANDLE TUBE EXTENSION
(SEE FIGURE 12)
• Install the lift handle tube extension on the lift handle
tube using a 1/4" x 1-3/4" hex bolt (I) and 1/4" nylock
nut (U).
STEP 14: INSTALL LIFT CABLE
(SEE FIGURE 13)
• Connect the hooked end of the lift cable into the index
rod, and install the threaded cable adjuster into the
notch in the top of the index bracket, placing a nut on
each side of the notch.
• Adjust the cable adjustment nuts so that when the lift
trigger is squeezed, the bottom of the index rod raises
enough to release from the latched position. The index
rod should also lower far enough to lock in the latched
position when the trigger is released.
• Attach the lift cable to the lift handle using three cable
ties (OO).