Manual

Mowing
position
Hairpin
cotter
Mountin(
pin
Handle
ENGINE
ENGINE SPEED
Your engine speed has been factory set. Do
not attempt to increase engine speed or itmay
result in personal injury. If you believe that
engine is running too fast or too slow, take
your mower to a Husqvarna or other qualified
service center for repair and adjustment.
CARBURETOR
LOW POSITION HIGH POSITION
Lower
handle
ROTATE
Your carburetor is not adjustable. If your
engine does not operate properly due to sus-
pected carburetor problems, take your lawn
mower to a Husqvarna or other qualified ser-
vice center for repair and/or adjustment.
IMPORTANT: Nevertamperwith the engine
governor, which is factory set for proper en-
gine speed. Overspeeding the engine above
the factory high speed setting can be danger-
ous. If you think the engine-governed high
speed needs adjusting, contact a Husqvarna
or other qualified service center, which has
proper equipment and experience to make
any necessary adjustments.
Immediately prepare your lawn mower for storage at the end of the season or if the unit
will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a
period of time, clean it thoroughly, remove
all dirt, grease, leaves, etc. Store in a r_
clean, dry area.
1. Cleanentirelawn mower(See"CLEANING"
in the Maintenance section ofthis manual).
2. Lubricate as shown in the Maintenance
section of this manual.
3. Be sure that all nuts, bolts, screws, and
pins are securely fastened. Inspect
moving parts for damage, breakage i
and wear. Replace if necessary.
4. Touch up all rusted or chipped paint
surfaces; sand lightly before painting.
HANDLE
You can fold your mower handle for storage.
1. Squeeze the bottom ends of the lower
handle toward each other until the
lower handle clears the handle bracket,
then move handle forward.
2. Loosen upper handle mounting bolts
enough to allow upper handle to be
folded back.
IMPORTANT: When folding the handle for
storage or transportation, be sure to fold
the handle as shown or you may damage
the control cables.
• When setting up your handle from the
storage position, the lower handle will
automatically lock into mowing position.
J
SQUEEZE
TO FOLD
Lower handle
!
i
I I
I I
L
Operator
control bar
MOWING
POSITION
FOLD
FORWARD
FOR
STORAGE
/ Upper
handle
Handle
knob
Lower handle
16