Product Manual

ASSEMBLY

TO INSTALL HOOD SCOOP (See Fig. 5)

Fig. 5

CONNECT BATTERY (See Fig. 4)

WARNING: Do not short battery ter mi nals

by allowing a wrench or any other object

to contact both terminals at the same

time. Before connecting battery, remove

metal bracelets, wristwatch bands, rings,

etc. Positive terminal must be connected

ﬁ rst to prevent sparking from ac ci den tal

grounding.

NOTE: If this battery is put into service after month and

year indicated on label (label is located between terminals)

charge battery for minimum of one hour at 6-10 amps. (See

“BATTERY” in the Maintenance section of this manual for

charging instructions.)

• Determine battery location. Battery location will be

under the seat or the hood.

• Lift seat pan or hood to raised position.

• Remove two terminal caps and discard.

• First connect RED battery cable to positive (+) terminal

with bolt and nut as shown. Tighten securely. Slide

terminal cover over terminal.

• Connect BLACK grounding cable to negative (-)

ter mi nal with remaining bolt and nut. Tighten se cure ly.

Fig. 4

02605

NUT

POSITIVE

(RED)

CABLE

NEGATIVE

(BLACK)

CABLE

BOLT

TERMINAL

COVER

LABEL

TERMINAL

CAP