Warranty Guide

ASSEMBLY

TO ASSEMBLE GRASS CATCHER

(See Fig. 3)

1. Put grass catcher frame into grass bag with rigid part

of bag on the bottom. Make sure the frame handle is

outside of the bag top.

2. Slip vinyl bindings over frame.

NOTE: If vinyl bindings are too stiff, hold them in warm water

for a few minutes. If bag gets wet, let it dry before using.

TO INSTALL ATTACHMENTS

Your lawn mower was shipped ready to be used as a

mulcher. To convert mower to bagging or discharging,

see “TO CON VERT MOWER” in the Operation section of

this man u al.

FIG. 3

FRAME

HANDLE

VINYL

BINDINGS

FRAME

OPENING

FIG. 2

HANDLE

BRACKET

BOLT

KNOB

INSTALL STARTER ROPE (See Fig. 4)

1. Loosen T-knob.

2. Place throttle control in STOP position.

3. Slowly pull engine starter rope out until rope will slip

into loop of rope guide.

4. Tighten T-knob.

FIG. 4

THROTTLE CONTROL

“STOP” POSITION

ENGINE

STARTER

ROPE

ROPE GUIDE T-KNOB