WHEELED WEEDTRIMMER 115648927 10.04.13 BY Printed in U.S.A.
TABLE OF CONTENTS Maintenance .......................................8-11 Service and Adjustments ..................11-12 Storage ............................................ 12-13 Troubleshooting .....................................14 Safety Rules ........................................ 2-3 Assembly .................................................4 Operation ............................................. 5-7 Maintenance Schedule ............................
TROUBLESHOOTING - See appropriate section in manual unless directed to a qualified service center. PROBLEM Does not start CAUSE CORRECTION 1. Dirty air filter. 2. Out of fuel. 3. Stale fuel. 4. Water in fuel. 5. Spark plug wire is disconnected. 6. Bad spark plug. 7. Throttle control lever not in correct position (if equipped). Loss of power Excessive Vibration 1. Clean/replace air filter. 2. Fill fuel tank. 3. Empty fuel tank and refill with fresh, clean gasoline. 4.
. Touch up all rusted or chipped paint surfaces; sand lightly before painting. ASSEMBLY Read these instructions and this manual in its entirety before you attempt to assemble or operate your new trimmer. IMPORTANT: This trimmer is shipped WITHOUT OIL OR GASOLINE in the engine. Your new trimmer has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. All parts such as nuts, washers, bolts, etc.
11. Assemble new belt, idler pulleys and bottom belt keeper to idler bracket. Tighten pulley bolts securely. NOTE: Be sure belt is inside top belt keeper on idler assembly. 12. Position belt and idler assembly in trimmer, reconnect idler spring and assemble idler to chassis. 13. Install belt around trimmer head pulley and engine pulley. NOTE: Be sure belt is inside belt keeper. 14. Replace debris shield and tighten the four (4) screws securely. 15. Replace chassis cover and tighten screw securely.
The operation of any trimmer can result in foreign objects being thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your trimmer or performing any adjustments or repairs. We recommend standard safety glasses or a wide vision safety mask worn over spectacles. HOW TO USE YOUR TRIMMER ENGINE SPEED The engine speed is controlled by a throttle located on the side of the upper handle. FAST position is for starting and normal trimming.
TO REPLACE TRIMMER LINE 1. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with spark plug. 2. Remove worn trimmer line from line carrier plate. 3. Fold new, cut to length, trimmer line in half and insert folded end through carrier plate opening to back side of retainer clip. 4. With folded end of line at back side of retainer clip, pull line outward until line is fully seated under retainer clip. 5. Repeat on other side of carrier plate. 6.
MAINTENANCE TRIMMER 20" MODELS Always observe safety rules when performing any maintenance. Chassis cover TIRES • Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber. • Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage. Wrap line around Debris shield mark TRIMMER LINE For best results, replace trimmer lines when they have worn to half their original length. End of spooled line New trimmer line 20" models use .
