Operating Guide

20
SERVICE AND ADJUSTMENTS
TO ADJUST CABLE TENSION (See Fig. 29)
Adjust cable tension by turning the adjuster turn buckle,
located on the right hand cable. Grasp the long section
tightly and turn the short section to lengthen the adjuster.
Adjust until cable is snug.
ADJUSTER TURN
BUCKLE
FIG. 29
ENGINE
SEE ENGINE MANUAL.
CARBURETOR
Your carburetor is not adjustable. Engine performance
should not be affected at altitudes up to 2,134 meters. If
your engine does not operate properly due to suspected
carburetor problems, take your snow thrower to a service
center/department.
ENGINE SPEED
Never tamper with the engine governor, which is factory set
for proper engine speed. Overspeeding the engine above
the factory high speed setting can be dangerous and will
void the warranty. If you think the engine-governed high
speed needs adjusting, contact a service center/depart-
ment, which has the proper equipment and experience to
make any necessary ad just ments.
TO ADJUST TRACTION BELT AND AUGER BELT
TENSION
If the traction or auger belt is slipping because it is not tight
enough when engaged, the tension can be increased by
adjusting the spring location in the control rod. Unhook
the rod from the control lever and move the spring at the
bottom of the rod one or two holes closer to the top of the
rod. This effectively shortens the rod and increases the
belt tension. (See "INSTALL AUGER CONTROL ROD" in
the Assembly section of this manual.)
TO REMOVE TRACKS (See Fig. 28)
1. Remove cross brace by removing 2 bolts, lock
washers and washers from the left and right track
assemblies and pulling brace out.
2. Remove the 2 large springs attached to inside of
tracks.
3. Remove the klik pin from axle.
4. Pull track off axle.
FIG. 28
AXLE
SPRING
BOLT
LOCK
WASHER
WASHER
KLIK
PIN
CROSS
BRACE
TRACK
ASSEMBLY
NOTE: For track replacement or for tension adjustments,
contact an authorized service center/department