40cm Petrol Wheeled Rotary Lawnmower Original Instructions ION T A RM NFO I T N RTA use O nce P e r e r IM e f o f be re re Read in for futu a & ret For all customer enquiries or for replacement parts, contact:- ☎ 01325 300303 www.flymo.com customer.services@husqvarna.co.
Carton Contents Brake lever Cable tie Powerdrive lever (If fitted) Cord guide nut Cable tie Cord guide washer x2 Upper Handle Cord guide Handle knob Cord guide nylock nut Lower handle plug x2 Handle knob washer Grassbox Upper Lower Handle screws x2 Lower Handle Grassbox Lower Instruction manual IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna UK Ltd.
Safety Precautions If not used properly this lawnmower can be dangerous! This lawnmower can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this lawnmower. The operator is responsible for following the warning and safety instructions in this manual and on the lawnmower. Never use the mower unless the grassbox or guards provided by the manufacturer are in the correct position. General 1.
Assembly Instructions A1 A2 Lower Handles 1. Insert the lower handle into the deck as shown in Fig. A1 2. Push the handle firmly down until it is located securely into the deck. 3. Insert the screw into the hole using a pozidrive screwdriver and tighten fully. (A2). Repeat for other side Lower Handle Plug A3 B1 1. Insert the two lower handle plugs into the top of each of the lower handles (A3). B2 Upper Handles When viewing product from the rear the yellow Warning labels should be facing upwards. 1.
Assembly Instructions cont’ D1 Grassbox Assembly D2 2. When the location points are matched correctly firmly press the grassbox together until all clips are securely connected. (D2) 1. Position the two grassbox halves together (D1) and press each location point into position without fully connecting the clips. Cutting Height Adjustment E1 E2 Cutting Height The cutting height can be adjusted by removing the front and back wheels on the product. 1.
Starting and Stopping F1 F2 Please note:- When starting the engine for the first time, fill with oil and petrol as described above in the Engine Notes section. PUSH LAWNMOWER 1. Connect the spark plug lead. Starting the cold engine Push primer bulb firmly 3 times before starting cold engine. (F1) (Also, if the engine has stopped because it has ran out of fuel, refuel engine and push primer 3 times). Starting the warm engine NOTE: Priming is usually unnecessary when restarting a warm engine.
Maintenance cont’ Transport Remove the spark plug lead Loosen the wire/cable from the handle before carefully folding it. Avoid damaging the wire/cable. Empty the petrol tank. The machine must be drained of oil and fuel when moving it by public transport. Service When ordering spare parts, always quote the mower’s product number. Always check oil level after service. At the End of the Mowing Season 1. Replace blade, bolts, nuts or screws, if necessary. 2. Clean your lawnmower thoroughly. 3.
Environmental Information ENVIRONMENTAL INFORMATION Husqvarna UK Ltd. are manufactured under an Environmental Management System (ISO 14001) using, where practical, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling at the end of the products’ life. • Packaging is recyclable and plastic components have been labelled (where practical) for categorised recycling.
