Product Manual

Table Of Contents
Assembly
Introduction
WARNING: Before you assemble the
product, you must read and understand the
safety chapter.
WARNING: Remove the spark plug
cable from the spark plug before you
assemble the product.
To assemble the throttle handle
1. Remove the screw behind the throttle handle.
2. Move the throttle handle to the right side of the
handlebar.
3. Align the hole behind the throttle handle with the
hole in the handlebar.
4. Put the screw through the holes. Tighten the screw.
To assemble the handlebar
1. Remove the knob and attach the handlebar as given
in the illustration.
2. Tighten the knob lightly.
3. Put on the harness and hang the product from the
suspension point.
4. Adjust the handle to put the product in a good work
position.
5. Tighten the knob fully.
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING: Use protective gloves.
WARNING: Always use the cutting
attachment guard that is recommended for
the cutting attachment. See
Accessories on
page 25
.
WARNING: An incorrectly attached
cutting attachment can result in injury or
death.
To attach the guard extension
CAUTION:
Use the guard extension
when you use a trimmer head/plastic blade.
Do not use the guard extension when you
use a grass blade.
1. Put the guard extension in the groove of the cutting
attachment guard.
975 - 004 - 30.01.2021
11