Product Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Safety definitions
- General safety instructions
- Safety instructions for assembly
- Safety instructions for operation
- Personal protective equipment
- Safety devices on the product
- Fuel safety
- Safety instructions for maintenance
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Transportation and storage
- Technical data
- Accessories
- Warranty
Maintenance Daily Weekly Monthly
Make sure that the cutting attachment does not rotate at idle speed. X
Do a check of the stop switch. Refer to
To do a check of the stop switch on page
8
.
X
Examine the cutting attachment guard for damages and cracks. X
Make sure that the grass blade is aligned with the center. Make sure that the
grass blade is sharp and that the blade or center hole is not damaged.
X
Examine the trimmer head for damages and cracks. Replace if it is damaged. X
Examine the handle and handlebar for damage and make sure that they are at-
tached correctly.
X
For cutting attachments with a support cup, tighten the locking screw fully. X
For cutting attachments with a locknut, tighten the locknut fully. X
Examine the transport guard for damage and make sure that it can be attached
correctly.
X
Examine the engine, the fuel tank and the fuel lines for leaks. X
Clean the air filter. Replace if it is necessary. X
Tighten nuts and screws. X
Examine the fuel filter for contamination and the fuel hose for cracks and other
defects. Replace if it is necessary.
X
Examine all cables and connections. X
Examine the starter and the starter rope for damages. X
Examine the vibration damping units for damages and cracks. X
Examine the spark plug. Refer to
To do a check of the spark plug on page 22
. X
Clean the cooling system. X
Make sure that the bevel gear is filled to ¾ with grease. X
Clean the external surface of the carburetor and the area around it. X
Clean the spark plug. Remove the spark plug and do a check of the electrode
gap. Adjust the electrode gap to 0.5 mm or replace the spark plug if it is neces-
sary. Make sure that the spark plug is assembled with a supressor.
X
Clean or replace the spark arrestor mesh on the muffler. X
Examine the clutch, clutch springs and the clutch drum for wear. Replace if it is
necessary.
X
Replace the spark plug. Make sure that the spark plug is assembled with a su-
pressor.
X
Lubricate the drive shaft.
1
X
Make sure that the safety release on the harness is not damaged and operates
correctly.
X
Examine and clean the spark arrestor mesh on the muffler. X
1
At an interval of 6 months.
20 975 - 004 - 30.01.2021