Operator's Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Operation
- Introduction
- To do a function check before you use the product
- Chain oil
- Common questions about kickback
- To connect the battery charger
- To charge the battery
- To start the product
- To use the SavE function
- To stop the product
- Kickback information
- To use the cutting technique
- To use the limbing technique
- To use the tree felling technique
- Maintenance
- Introduction
- Maintenance schedule
- Maintenance and checks of the safety devices on the product
- To do a check of the battery and the battery compartment
- To do a check of the battery charger
- To clean the cooling system
- To sharpen the saw chain
- To tighten the saw chain
- To do a check of the saw chain lubrication
- To do the maintenance on the chain drive sprocket
- To examine the cutting equipment
- To do a check of the guide bar
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Accessories
- Warranty
- Introduction
- Sécurité
- Montage
- Fonctionnement
- Introduction
- Pour vérifier le fonctionnement avant d’utiliser le produit
- Huile pour chaîne
- Questions fréquentes à propos du rebond
- Pour brancher le chargeur de batterie
- Pour charger la batterie
- Mise sous tension de l’appareil
- Pour utiliser la fonction SavE (économie)
- Mise hors tension de l’appareil
- Renseignements sur le rebond
- Pour utiliser la technique de coupe
- Pour utiliser la technique d’élagage
- Pour utiliser la technique d’abattage d’arbre
- Entretien
- Introduction
- Calendrier d’entretien
- Entretien et vérifications des dispositifs de sécurité du produit
- Pour vérifier la batterie et le compartiment de batterie
- Vérifier le chargeur de batterie
- Nettoyage du système de refroidissement
- Affûter la chaîne.
- Pour serrer la chaîne
- Vérification de la lubrification de la chaîne
- Pour effectuer l’entretien du pignon d’entraînement de la chaîne
- Pour examiner l’équipement de coupe
- Pour vérifier le guide-chaîne
- Dépannage
- Transport, entreposage et mise au rebut
- Données techniques
- Accessoires
- Garantie
- Introducción
- Seguridad
- Montaje
- Funcionamiento
- Introducción
- Para realizar una comprobación de funcionamiento antes de utilizar el producto
- Aceite para cadena
- Preguntas frecuentes acerca de las reculadas
- Para conectar el cargador de la batería
- Para cargar la batería
- Para poner en marcha la máquina
- Utilice la función de ahorro (SavE)
- Para detener la máquina
- Información de reculada
- Para utilizar la técnica de corte
- Para utilizar la técnica de desramado
- Para utilizar la técnica de tala
- Mantenimiento
- Introducción
- Programa de mantenimiento
- Mantenimiento y comprobaciones de los dispositivos de seguridad en el producto
- Para comprobar la batería y el compartimiento de la batería
- Para comprobar el cargador de la batería
- Para limpiar el sistema de refrigeración
- Para afilar la cadena de sierra
- Para apretar la cadena de sierra
- Para realizar una comprobación de la lubricación de la cadena de sierra
- Cómo realizar mantenimiento al piñón de arrastre de la cadena
- Para examinar el equipo de corte
- Para comprobar la espada guía
- Solución de problemas
- Transporte, almacenamiento y eliminación de residuos
- Datos técnicos
- Accesorios
- Garantía
Table 3: Battery charger
LED display Possible faults Possible action
Warning indicator flashing. Temperature deviation. Use the battery in surroundings
where temperatures are between
5°C/41°F and 40°C/104°F.
Warning indicator lit. Turn to your servicing dealer.
Transportation, storage and disposal
Transportation and storage
• The supplied Li-ion batteries obey the Dangerous
Goods Legislation requirements.
• Obey the special requirement on package and labels
for commercial transportation, including by third
parties and forwarding agents.
• Speak to a person with special training in dangerous
material before you send the product. Obey all
applicable national regulations.
• Use tape on open contacts when you put the battery
in a package. Put the battery in the package tightly
to prevent movement.
• Remove the battery for storage or transportation.
• Put the battery and the battery charger in a space
that is dry and free from moisture and frost.
• Do not keep the battery in an area where static
electricity can occur. Do not keep the battery in a
metal box.
• Put the battery in storage where the temperature is
between 5°C/41°F and 25°C/77°F and away from
open sunlight.
• Put the battery charger in storage where the
temperature is between 5 °C/41 °F and 45°C/113°F
and away from open sunlight.
• Use the battery charger only when the surrounding
temperature is between 5°C/41°F and 40°C/104°F.
• Charge the battery 30% to 50% before you put it in
storage for long periods.
• Put the battery charger in storage in a space that is
closed and dry.
• Keep the battery away from the battery charger
during storage. Do not let children and other not
approved persons to touch the equipment. Keep the
equipment in a space that you can lock.
• Clean the product and do a full servicing before you
put the product in storage for a long time.
• Use the transportation guard on the product to
prevent injuries or damage on the product during
transportation and storage.
• Attach the product safely during transportation.
Disposal of the battery, battery charger
and product
Symbols on the product or the package of the product
means that the product is not domestic waste. Recycle it
at a recycling station for electrical and electronic
equipment. This helps to prevent damage to the
environment and to persons.
Get in touch with your local authorities, domestic waste
service or your dealer for more information about how to
recycle your product.
Technical data
Technical data
120i
Platform CS100UL
Motor
Type BLDC (brushless) 36V
Features
1259 - 003 - 14.09.2020 25