Operator’s manual 115iL Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.
1 10 1 3 5 4 1 2 20 19 3 6 8 7 16 18 9 4 17 15 14 13 12 11 21 5 3 6 1 7 2 1 2 8 9 10 11 12 13 3 14 2 1 15 16 CLICK!
17 18 19 20 21 22 23 24 25 26 27 28 (2) 3 (1) 2 1 3 29 30 31 32 33 34 35 36 37 2 1
KEY TO SYMBOLS Symbols on the machine: Do not expose to rain. Translation of the original Swedish operating instruction. WARNING! Trimmers can be dangerous! Careless or incorrect use can result in serious or fatal injury to the operator or others. It is extremely important that you read and understand the contents of the operator’s manual. Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.
CONTENTS Contents KEY TO SYMBOLS Symbols on the machine: ..................................... Symbols on the battery and/or on the battery charger: ................................................................ CONTENTS Contents ............................................................... Note the following before starting: ........................ INTRODUCTION Dear customer! ..................................................... What is what? .......................................................
INTRODUCTION Dear customer! What is what? Congratulations on your choice to buy a Husqvarna product! Husqvarna is based on a tradition that dates back to 1689, when the Swedish King Karl XI ordered the construction of a factory on the banks of the Huskvarna River, for production of muskets. The location was logical, since water power was harnessed from the Huskvarna River to create the water-powered plant.
GENERAL SAFETY PRECAUTIONS General power tool safety warnings tools. Unmodified plugs and matching outlets will reduce the risk of electric shock. • WARNING! When using electric gardening appliances, basic safety precautions should always be followed to reduce the risk of electric shock, fire and/or serious injurym including the following: Avoid body contact with earthed or grounded surfaces, such as pipes, radiators, ranges and refrigerators.
GENERAL SAFETY PRECAUTIONS can make a connection from one terminal to another. Shorting the battery terminals together may cause burns or a fire. these are connected and properly used. Use of dust collection can reduce dust-related hazards. • The vibration emission during actual use of the power tool can differ from the declared total value depending on the ways in which the tool is used.
GENERAL SAFETY PRECAUTIONS IMPORTANT! The cutting tool does not stop immediately after the machine is turned off. This appliance is not intended for use by person (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. beyond your capability.
GENERAL SAFETY PRECAUTIONS • • Wear clothes made of a strong fabric and avoid loose clothing that can catch on twigs and branches. Always wear heavy, long pants. Do not wear jewellery, shorts sandals or go barefoot. Secure hair so it is above shoulder level. Always have a first aid kit nearby. Machine′s safety equipment This section describes the machine′s safety equipment, its purpose, and how checks and maintenance should be carried out to ensure that it operates correctly.
GENERAL SAFETY PRECAUTIONS IMPORTANT! Only use cutting attachments with the guards we recommend! See the chapter on Technical data. Refer to the instructions for the cutting attachment to check the correct way to load the line and the correct line diameter. Always remove the battery before you work on any part of the cutting equipment. It continues to rotate even after the throttle control has been released.
ASSEMBLY Trimmer guard • Slide the trimmer guard into the trimmer head. (Figure 34) • Fasten the trimmer guard onto the housing to the trimmerhead. (Figure 35) Fitting the trimmer head • Turn the output shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing. • Insert the locking pin into the hole to lock the axle. • Screw on the trimmer head in the opposite direction to the direction of rotation.
BATTERY HANDLING Battery The display shows the battery capacity and if there are any problems with the battery. The battery capacity is displayed for 5 seconds after the machine is switched off or the battery indicator button (1) is pressed. The warning symbol on the battery is lit when an error has occurred (2). See fault codes. (Figure 27) LED lights Battery status All LEDs are lit Fully charged (67%– 100%). LED 1, LED 2 are lit. The battery is 34%-66% charged. LED 1 is lit.
STARTING AND STOPPING Check before starting • Check the product for dirt and cracks. Clean off grass and leaves from the motor housing using a brush. Gloves should be worn when necessary. • Check that the trimmer head is completely attached to the trimmer. • Check that the machine is in perfect working order. Check that all nuts and screws are tight. • Check that the trimmer head and trimmer guard are not damaged or cracked.
WORKING TECHNIQUES General working instructions IMPORTANT! This section takes up the basic safety precautions for working with a lawn trimmer. If you encounter a situation where you are uncertain how to proceed you should ask an expert. Contact your dealer or your service workshop. Avoid all usage which you consider to be beyond your capability. ! WARNING! The machine can cause serious personal injury. Read the safety instructions carefully. Learn how to use the machine.
WORKING TECHNIQUES • Loosen the lock on the shaft and set the desired length on the shaft and lock. Cutting • The trimmer is ideal for cutting grass that is difficult to reach using a normal lawn mower. Keep the cord parallel to the ground when cutting. Avoid pressing the trimmer head against the ground as this can ruin the lawn and damage the tool. (Figure 21) • Do not allow the trimmer head to constantly come into contact with the ground during normal cutting.
MAINTENANCE Inspection and maintenance Replace the trimmer head. • ! WARNING! Always disconnect the battery before any maintenace on the machine. Carry the hedge trimmer by the handle with the cutter blade stopped. Insert the locking pin (C) in the hole to lock the shaft. (Figure 33) • Screw the trimmer head counterclockwise. • Fit the trimmer head. IMPORTANT! Never clean the battery or the battery charger with water. Strong cleaning agents can damage the plastic.
MAINTENANCE Troubleshooting schedule Troubleshooting takes place from the keypad. Keypad Keypad Possible faults Possible action The trimmerhead is jammed. Warning indicator flashing. Overload. Remove the battery from the machine. Release the trimmer head from grass. Temperature deviation. Allow the machine to cool down. Dirt in battery connectors. Clean with compressed air or a soft brush. The power trigger and the activate button are pressed at the same time.
MAINTENANCE Maintenance schedule ! WARNING! Always disconnect the battery before any maintenace on the machine. Carry the hedge trimmer by the handle with the cutter blade stopped. The following is a list of the maintenance that must be performed on the machine. Most of the items are described in the Maintenance section. Maintenance Daily Maintenance Clean the outside of the machine with a clean and dry cloth. Never use water. X Keep handles dry, clean and free from oil and grease.
TECHNICAL DATA Technical data 115iL Platform T100UL Motor Motor type BLDC Speed of output shaft, rpm 5500 Cutting width, inch/mm 13/330 14/355 Weight Weight without battery, Lbs/kg 7,39/3,35 Weight with battery, Lbs/kg 10,1/4,6 Battery runtime Battery runtime, min, (free run) with SavE activated 97 Approved batteries for 115iL. Battery BLi20 Type Lithium-ion Battery capacity, Ah 4.2 (VTC4) 4 (HD2) Voltage, V 36 36.5 Weight, lb/kg 2.6/1.2 2.6/1.
115iL Trimmer head 1 2 2,0 mm .
Husqvarna AB SE-561 82 Huskvarna Visiting address: Drottninggatan 2 1158312-95 ´®z+Z?=¶5§¨ ´®z+Z?=¶5§¨ 2016-12-20