Use and Care Guide
min 30 cm / 12”
min 30 cm / 12”
WARNING: No parts of the power supply must
under any circumstances be changed or
tampered with. The low voltage cable must not
be shortened or extended.
CAUTION: Place the low voltage cable so that
the blades on the blade disc can never come in
contact with it.
CAUTION: Use the plug to disconnect the
charging station, for instance before cleaning or
repairing the loop wire.
3.3.3 Installing and connecting the charging station
1. Position the charging station in a suitable spot.
2. Tilt the protective cover on the charging station
forward and connect the low voltage cable to the
charging station.
3. Connect the power supply’s power cable to a
100-240V wall socket. If the power supply is
connected to an electrical socket outdoors, this must
be approved for outdoor use. See
Connecting the
power supply on page 13
.
4. Attach the charging station to the ground using the
supplied screws. Ensure the screws are screwed all
the way down in the countersink. If the charging
station is placed against a wall, it is best to wait
before securing the charging station to the ground
until after all the wires have been connected.
CAUTION: It is not permitted to make new holes
in the charging station’s plate. Only the existing
holes may be used to secure it to the ground.
CAUTION: Do not tread or walk on the charging
station’s plate.
3.4 Charging the battery
When the charging station is connected, it is possible to
charge the robotic lawnmower. Set the main switch to
position
1
.
Place the robotic lawnmower in the charging station
while the boundary and guide wires are being laid.
If the battery is flat, it takes around 80 to 100 minutes to
fully charge it.
WARNING: Only charge the robotic lawnmower
using a charging station which is intended for it.
Incorrect use may result in electric shock,
overheating or leakage of corrosive liquid from
the battery. In the event of leakage of electrolyte
flush with water and seek medical help if it
comes in contact with the eyes etc.
Note: The robotic lawnmower cannot be used before the
installation is complete.
14 - Installation 473 - 001 -