Use and Care Guide

3.13.4 Copy
Use this function to copy the current day settings to
other days.
Mark Copy by using arrow keys and press OK. Then use
the up and down arrow keys to move the cursor
between days. The times will be copied to the days that
are marked with OK.
3.13.5 Reset
This function resets the timer to the factory setting,
where the robotic lawnmower is allowed to operate 24
hours a day every day.
Reset timer
Current day
All week
3.13.5.1 Current day
This resets the day that is selected in the tab system.
The factory setting is that the robotic lawnmower is
allowed to operate 24 hours a day.
3.13.5.2 All week
This resets all days in the week.
The factory setting is that the robotic lawnmower is
allowed to operate 24 hours a day every day.
3.14 Security
Through this selection, settings relating to security and
the connection between the robotic lawnmower and the
charging station can be made.
SECURITY
Security level
Advanced
3.14.1 Security level
There are 3 security levels to choose from.
Security level
Low
Medium
High
Low and Medium security prohibits access to the robotic
lawnmower if the PIN code is unknown. High security
also includes a warning that beeps if the correct PIN
code is not entered after a designated time period.
If the wrong PIN code is entered 5 times in succession
the robotic lawnmower is blocked for a time. The
blockage time is extended for every new incorrect
attempt.
Function Low Medium High
Time lock X X X
PIN request X X
Alarm X
3.14.1.1 Time lock
This function means that the robotic lawnmower cannot
be started after 30 days without first entering the correct
PIN code. When the 30 days has passed the robotic
lawnmower will continue to mow as normal, but the
Enter PIN code message appears when the hatch is
opened. Enter your code again and press OK.
3.14.1.2 PIN request
This function means that the robotic lawnmower
requests a PIN code when the main switch is set to 1
and each time the hatch is opened. The correct PIN
code must be entered to use the robotic lawnmower.
If the wrong PIN code is entered 5 times in succession
the robotic lawnmower is blocked for a time. The
blockage time is extended for every new incorrect
attempt.
3.14.1.3 Alarm
This function means that an alarm sounds if the PIN
code is not entered within 10 seconds after the STOP
button has been pressed or the robotic lawnmower has
been lifted up for any reason. A ticking noise indicates
that the PIN code must be entered to prevent triggering
the alarm. The alarm can be turned off at any time by
entering the correct PIN code.
3.14.2 Advanced
Advanced
New loop signal
Change PIN code
Duration
3.14.2.1 New loop signal
The loop signal is randomly selected to create a unique
link between the robotic lawnmower and the charging
station. In rare cases, there may be a need to generate
a new signal, for instance if two adjacent installations
have a very similar signal.
1. Place the robotic lawnmower in the charging station.
2. Select
New loop signal in the menu.
3. Press OK and await confirmation that the loop signal
has been generated. This normally takes about 10
seconds.
473 - 001 - Installation - 25