Use and Care Guide

2. Use the right and left arrow keys to increase or
decrease the cutting time in 3 preset intervals.
3.17 Installation
For many working areas there is no need to change the
factory settings but sometimes, depending on the lawn
complexity, the mowing result can be improved by
making manual settings.
INSTALLATION
Find charging station
Advanced
Lawn coverage
3.17.1 Lawn coverage
This menu function is used to steer the robotic
lawnmower to remote parts of a working area. In
complex gardens with for instance many areas which
are joined by narrow passages, the mowing result can
be much improved by changing settings.
Up to 3 remote areas can be set. Select an area using
the left and right arrow keys followed by OK.
Lawn coverage
Area 1
Area 2
Area 3
Area3
Area2
Area1
A number of unique selections are required to allow the
robotic lawnmower to reach the remote area.
Area 1, 2 or 3
How?
How far?
How often?
Disable
More
Lawn coverage
The factory settings allow the robotic lawnmower to
follow the guide wire 300 m / 984 ft. in 20% of the times
it leaves the charging station. If the guide wire in reality
is less than 300 m / 984 ft. the robotic lawnmower will
follow it to the point where the guide wire is connected to
the boundary wire.
3.17.1.1 Area 1, 2 or 3 > How?
Specify to the right, left or Guide depending on which
direction the robotic lawnmower should go. The direction
(right or left) is counted as that seen facing the charging
station.
Use the right and left arrow keys to alternate between
the different options.
3.17.1.2 Area 1, 2 or 3 > How far?
Enter the distance in metres along the current wire from
the charging station to the remote area where the
robotic lawnmower begins mowing.
Use the right and left arrow keys to alternate between
the different options.
Tip! Use the Test function ( Area 1, 2 or 3 > More >
Test ) to determine how far it is to the remote area. The
distance, stated in metres, will be shown in the
lawnmower display when STOP has been pressed. See
How to measure the distance to a remote area on page
28 . The measured distance shown in the display can
be saved directly to the selected remote area. Any
current value will be overidden by the new measured
distance.
473 - 001 - Installation - 27