Operator's Manual

27
MAINTENANCE
12/12 Each year Lubricate with grease gun
1/52 Each Week Filter change
1/365 Each day Oil change
Level check
General
Remove the ignition key to prevent accidental
movements during lubrication.
When lubricating with an oil can, it must be lled
with engine oil. When lubricating with grease,
unless otherwise stated, use a high grade
molybdenum disulphide grease.
For daily use, the machine must be lubricated
twice weekly. Clean away unwanted grease after
lubrication.
It is important to avoid getting lubricant on the
belts or the drive surfaces of the belt pulleys.
If this occurs, try to clean them with spirits. If
the belt continues to slip after cleaning, the belt
must be replaced. Gasoline or other petroleum
products must not be used to clean belts.
IMPORTANT INFORMATION Use minimal
lubrication and remove unwanted lubricant so
it does not come into contact with belts or belt
pulley drive surfaces.
WARNING! Escaping hydraulic oil under
pressure can have su󰀩cient force to penetrate
the skin, causing dangerous injury. If injured
by escaping uid, see a doctor immediately. If
correct medical treatment is not administered it
can cause a dangerous infection or reaction.