Operator's Manual

5. Install the cable barrel fitting (F) to the release
lever (E).
6. Install the release lever (E) to the discharge
chute lever and attach it with the roll pin (C).
7. Adjust the release cable. See
To adjust the
release cable of the discharge chute on page
25 .
8. Adjust the left and right discharge chute cables.
See
To adjust the left and right discharge chute
cables on page 25 .
To install the remote control for the
discharge chute deflector
1. Attach the cable bracket (A) to the discharge
chute with a carriage bolt (B) and a 5/16-18
locknut (D). Tighten the bolt.
2. Install the cable eyelet (E) to the discharge chute
deflector (F). Use a shoulder bolt (G), a nylon
washer (C), and tighten with a ¼-20 locknut (K).
The cable eyelet will be loose on the shoulder
bolt.
3. Attach the spring (L) between the hex nut (M) on
the rotator head and the hole on the discharge
chute deflector.
F
L
M
B
A
D
K
C
E
G
To install the speed control cable
1. Put the drive speed lever in the neutral position.
2. Attach the speed control cable (B) to the drive
speed lever with a retaining pin.
3. Attach the speed control cable to the bracket (C)
with 2 ½ in wrenches. Make sure that the drive
speed lever stays in the neutral position.
4. Remove the screw and wing nut (A) on the
bellcrank to let the bellcrank move.
BA
C
To install the battery ground cable
1. Remove the battery cover.
2. Remove the screw for the battery ground cable.
12
876 - 014 - 19.05.2021