Operator's Manual

5. Move the product a minimum of 3 m (10 ft) from
the position where you filled the tank, before a
start.
To start the engine, manual start
1. Put the ON/OFF key into the ignition slot (B). Do
not turn the key.
B
A
C
D
2. Put the throttle control (A) to the FAST position.
3. Turn the ON/OFF key to the ON position.
4. Pull the starter rope handle (D).
CAUTION: Do not release the
starter rope handle quickly. Move it
slowly to the start position.
Note: If the starter rope is frozen, slowly pull
out as much rope out of the starter as you can.
Release the starter rope handle. If the engine
does not start, do the procedure again or use the
electric starter.
5. Run the engine 2-3 minutes at low speed before
you start to throw snow.
6. If the engine does not run smoothly, turn it off.
To start the engine, electric start
1. Put the ON/OFF key into the ignition slot (B). Do
not turn the key.
2. Put the throttle control (A) to the FAST position.
3. Put the ON/OFF key to the ON position.
B
A
C
D
4. Turn the ON/OFF key to START. When the
engine starts, release the key.
CAUTION: Do not run the
starter for more than 5 seconds each
time you try to start. Wait 5 to 10
seconds between each try.
5. Run the engine 2-3 minutes at low speed before
you start to throw snow.
To operate the product
CAUTION: Do not partially engage
drive or auger levers for an extended
period of time; this can lead to premature
wear or burning of the belts.
Note: When both the drive engagement and auger
engagement are engaged, the drive engagement will
lock the auger engagement in position. Use the right
hand to control the snow discharge chute.
1. To engage the auger blades, push the auger
engagement (A) to the handle to engage the
auger and throw snow.
A
14
876 - 014 - 19.05.2021