Operator's Manual

2. Turn the cable adjusters until the discharge chute
points straight forward, and the cables are tight.
3. Loosen the cable adjusters ¼ turn to make the
cables less tight.
To remove the wheels
1. Remove the wheel pin (A) and the retainer pin
(B).
2. Remove the wheel from the axle (C).
A
B
C
To adjust the tension of the
continuous tracks (for ST 424T/
427T/430T only)
Note:
Tools that are necessary for this task: a
9/16" deep socket, a 9/16" wrench and a 5 kg (10
lbs) weight.
1. Loosen the locking screw (A) 1 turn.
2. Remove the rear locknut (B) to give access to
the adjustment nut.
B
A
3. Put a 5 kg (10 lbs) weight (C) on top of the
continuous track, in the center between the 2
wheels.
4. Turn the adjustment nut (B) until the distance (D)
between the continuous track and the steel plate
is between 3.175 and 6.350 mm (0.125 and
0.250 in). wide.
10lb
D
C
5. Attach the locking screw (A) and then the rear
locknut (B).
To clean the product
• Clean plastic parts with a clean and dry cloth.
• Do not use a high pressure washer to clean the
product.
• Do not flush water directly on the motor.
• Use a brush to remove leaves, grass and dirt.
26
876 - 014 - 19.05.2021