Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Operation
- Before you start the product
- To fill the engine with oil
- To fill fuel
- To adjust the discharge chute and the chute deflector
- To start the engine, manual start
- To start the engine, electric start
- To operate the product
- To stop the product
- To use the throttle control
- To use the fuel switch
- To use the choke control
- To adjust the skid plates
- To prevent freeze-up after use
- To get a good result
- Maintenance
- Introduction
- Maintenance schedule
- To do a general inspection
- To do a check of the oil level
- To replace the engine oil
- To lubricate the product
- Muffler
- To examine the spark plug
- To inspect the augers and the scraper bar
- To replace the auger shear pins
- To replace the impeller shear pins
- To examine the tires
- To clear a clogged discharge chute deflector
- To replace the scraper bar
- Drive belts
- To adjust the tension of the cable for the discharge chute deflector
- To adjust the auger control cable
- To remove the wheels
- To clean the product
- Troubleshooting
- Transportation, storage and disposal
- Technical data
To stop the product
1. Move the ON/OFF switch to the OFF position (if
equipped).
2. Remove the ON/OFF key.
To use the throttle control
• Turn the throttle control (A) to change the
amount of fuel used. Always operate the engine
at full throttle.
CHOKE
CONTROL
TRUCTIONS
A
To use the fuel switch
• Turn the fuel switch to open or close the fuel
valve. Operate the product with the fuel switch in
the OPEN position.
OFF
ON
FUEL
CONTROL
INSTRUCTIONS
To use the choke control
• Turn the choke (A) to open or close the choke
valve. Use the choke to start a cold engine.
CHOKE
CONTROL
TRUCTIONS
A
To adjust the skid plates
The skid plates prevent damage to the bottom of the
snow thrower. Adjust the skid plates (A) when the
locknut (B) is loose, or the skid plate is not at the
correct distance from the ground. No adjustment is
necessary for standard installation.
1. Loosen the locknut (B) with a 13 mm (½ in.) open
wrench.
2. Move the skid plates (A) up or down.
a) On flat surfaces set the distance between the
scraper bar and the ground to 5-6 mm
(0.2-0.25 in).
b) On rough surfaces set the skid plates (A) in a
position where the scraper bar is above the
top of the ground.
WARNING: Make sure that
gravel and stones do not go into
the product. Objects that eject at
high speed can cause injury.
3. Tighten the locknut (B).
B
A
To prevent freeze-up after use
Note:
Controls and moving parts can be blocked by
ice. Do not apply much force to the controls. If you
cannot operate a control or a part, start the engine
and let it operate for some minutes.
1. Start the engine and let it operate for some
minutes. Stop the engine and wait for all moving
parts to stop.
2. Remove snow and loose ice from the product.
3. Remove snow and loose ice from the base of the
chute.
4. Turn the chute deflector to the left direction and
to the right direction to remove ice and water.
5. Remove the key or flip switch to the "OFF"
position (if equipped).
6. If the product does not have an electric starter,
pull the starter rope handle several times to
remove ice and water.
7. If the product has an electric starter, connect the
product to power and push the start button once
to remove ice and water.
694 - 006 - 12.05.2020
13