Manual

Table Of Contents

10. Disconnect the extension cord from the

receptacle first and then from the engine.

11. Run the engine 2-3 minutes at idling speed

before you start to throw snow.

To operate the product

CAUTION: Do not operate without snow

or water to lubricate the auger blades.

Incorrect use can cause high

temperatures in the auger blades,

especially if the product is new. This can

cause damage to the auger blades and

scraper bar.

CAUTION: Do not partially engage drive

or auger levers for an extended period of

time; this can lead to premature wear or

burning of the belts.

Note: When both the drive engagement and auger

engagement are engaged, the drive engagement will

lock the auger engagement in position. Use the right

hand to control the snow discharge chute.

Note: Do not change the speed when the drive lever

is engaged. This can cause damage to the

transmission.

1. To engage the auger blades, push the auger

engagement (A) to the handle to engage the

auger and throw snow.

2. Raise the drive speed control lever (B) from the

middle position to make the product move

forward when the drive engagement (C) is

engaged. Do not change the speed when the

drive lever is engaged. This can cause damage

to the transmission.

3. Lower the drive speed control lever from the

middle position to make the product move

rearward when the drive engagement is

engaged.

4. To make the product move in the selected

direction, hold the drive engagement (C) against

the handle .

5. If the product has power steering, hold the left

steering trigger (D) to turn left. Hold the right

steering trigger to turn right.

694 - 006 - 12.05.2020