Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Operation
- Before you start the product
- To fill the engine with oil
- To fill fuel
- To adjust the discharge chute and the chute deflector
- To start the engine, manual start
- To start the engine, electric start
- To operate the product
- To stop the product
- To use the throttle control
- To use the fuel switch
- To use the choke control
- To adjust the skid plates
- To prevent freeze-up after use
- To get a good result
- Maintenance
- Introduction
- Maintenance schedule
- To do a general inspection
- To do a check of the oil level
- To replace the engine oil
- To lubricate the product
- Muffler
- To examine the spark plug
- To inspect the augers and the scraper bar
- To replace the auger shear pins
- To replace the impeller shear pins
- To examine the tires
- To clear a clogged discharge chute deflector
- To replace the scraper bar
- Drive belts
- To adjust the tension of the cable for the discharge chute deflector
- To adjust the auger control cable
- To remove the wheels
- To clean the product
- Troubleshooting
- Transportation, storage and disposal
- Technical data
To get a good result
• Always run the engine at full throttle or near full
throttle.
• Always adapt the speed of the product to the
snow situation and adjust the speed with the
drive speed control lever. Make sure that the
product throws snow evenly.
• It is easier and more efficient to remove snow
immediately after it falls.
• Always throw snow downwind whenever
possible.
• On flat surfaces, like asphalt roads, raise the skid
plates up to 5-6 mm (0.2-0.25 in) off the ground.
• The scraper bar is reversible. When it becomes
worn almost to the edge of the housing, reverse
it. Replace the scraper bar if it is damaged, or if
both sides are worn.
• Do not dispatch the chute deflector if it is
clogged.
• If the product does not move forward due to
unforeseen circumstances, release the drive
engagement immediately or move the ON/OFF
key to the "OFF" position.
Maintenance
Introduction
When the product is in use, bolts can loosen and
components can become worn. This can cause
malfunction like incorrect tolerance clearance,
increased oil consumption, or misalignment of
various components. Do regular maintenance on the
product to prevent malfunction.
Maintenance schedule
Maintenance Daily 20 hours 50 hours 100 hours
Make sure that nuts
and screws are
tightened
X
Do a check of the
engine oil level
X
Replace oil
1
X X X
Make sure there are
no fuel or oil leaks
X
Remove clogging,
foreign objects in
auger
X
Inspect the tire
pressure
2
X
Inspect and change
the spark plug
3
X
Note: It is not necessary to add grease or to do other
maintenance to the gearbox.
To do a general inspection
• Make sure that all nuts and screws on the
product are tightened correctly.
To do a check of the oil level
CAUTION: A too low oil level can do
damage to the engine. Do a check of the
oil level before you start the product.
1. Put the product on level ground.
2. Remove the oil tank cap with the attached
dipstick.
3. Clean the oil from the dipstick.
4. Put the dipstick fully into the oil tank to give a
correct picture of the oil level.
1
Replace the oil after the first 20 h, 50 h, 100 h and then every 100 h.
2
See Technical data for correct tire pressure.
3
Check and clean spark plug before use each year.
14 694 - 006 - 12.05.2020