Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Operation
- Before you start the product
- To fill the engine with oil
- To fill fuel
- To adjust the discharge chute and the chute deflector
- To start the engine, manual start
- To start the engine, electric start
- To operate the product
- To stop the product
- To use the throttle control
- To use the fuel switch
- To use the choke control
- To adjust the skid plates
- To prevent freeze-up after use
- To get a good result
- Maintenance
- Introduction
- Maintenance schedule
- To do a general inspection
- To do a check of the oil level
- To replace the engine oil
- To lubricate the product
- Muffler
- To examine the spark plug
- To inspect the augers and the scraper bar
- To replace the auger shear pins
- To replace the impeller shear pins
- To examine the tires
- To clear a clogged discharge chute deflector
- To replace the scraper bar
- Drive belts
- To adjust the tension of the cable for the discharge chute deflector
- To adjust the auger control cable
- To remove the wheels
- To clean the product
- Troubleshooting
- Transportation, storage and disposal
- Technical data
A
2. Replace the scraper bar if it is worn on both
sides or if it is damaged.
Drive belts
WARNING: The v-belts on your product
are of special construction and should be
replaced by original equipment
manufacturer (OEM) belts available from
your nearest service center. Using other
than OEM belts can cause personal
injury or damage to the product.
WARNING: The belt replacement
requires separation of the product. While
separating the auger housing from the
frame, it is important that an assistant
stands in the operating position and
holds the product handles. Serious
personal injury and/or damage to the
product could occur if the product falls
during the belt replacement process.
Note: The auger and traction drive belts are not
adjustable. Replace the belts if they are damaged or
begin to slip from wear. It is recommended to have
the belts replaced by a qualified service center.
Note: It is recommended to replace the drive belt
and auger belt at the same time.
To prepare for replacement of the belts
1. Remove the fuel from the fuel tank.
2. Loosen the lock nut (A) that secures the chute
rotator head (B) to the mounting bracket (C) to
remove the discharge chute.
B
A
C
3. Loosen the two screws (A) that secure the belt
cover (B) to the frame (C) and remove the belt
cover.
C A
B
To remove the drive belt
1. Remove the auger belt. See
To remove the
auger belt on page 18
.
2. Remove the tensioner spring (A) attached to the
drive belt tensioner arm (B).
A
B
C
D
E
H
FG
I
J
3. Remove the return spring (C) holding the swing
plate (D) in place.
694 - 006 - 12.05.2020
17