Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Operation
- Before you start the product
- To fill the engine with oil
- To fill fuel
- To adjust the discharge chute and the chute deflector
- To start the engine, manual start
- To start the engine, electric start
- To operate the product
- To stop the product
- To use the throttle control
- To use the fuel switch
- To use the choke control
- To adjust the skid plates
- To prevent freeze-up after use
- To get a good result
- Maintenance
- Introduction
- Maintenance schedule
- To do a general inspection
- To do a check of the oil level
- To replace the engine oil
- To lubricate the product
- Muffler
- To examine the spark plug
- To inspect the augers and the scraper bar
- To replace the auger shear pins
- To replace the impeller shear pins
- To examine the tires
- To clear a clogged discharge chute deflector
- To replace the scraper bar
- Drive belts
- To adjust the tension of the cable for the discharge chute deflector
- To adjust the auger control cable
- To remove the wheels
- To clean the product
- Troubleshooting
- Transportation, storage and disposal
- Technical data
A
B
C
To clean the product
• Clean plastic parts with a clean and dry cloth.
• Do not use a high pressure washer to clean the
product.
• Do not flush water directly on the motor.
• Use a brush to remove leaves, grass and dirt.
Troubleshooting
Troubleshooting
Problem Possible cause Solution
The product does not
start
The safety ignition key is not inserted. Insert the safety ignition key.
The product is out of fuel. Fill the fuel tank with fresh, clean
gasoline.
The ON/OFF key is OFF. Move the ON/OFF key to ON posi-
tion.
The choke is in OFF (CLOSE) position. Move the choke to ON (FULL,
OPEN) position.
The primer is not depressed. Press the primer.
The engine is flooded. Wait a few minutes before restart-
ing, DO NOT prime.
Restart the engine while full throt-
tle and the choke in OFF (CLOSE)
position.
The spark plug cable is not connected. Connect the cable to the spark
plug.
The spark plug is bad. Replace the spark plug.
There is water in the fuel or the fuel is too
old.
Empty the fuel tank and carburet-
or. Fill the fuel tank with fresh,
clean gasoline.
There is vapor locked in the fuel line. Make sure that all the fuel line is
below the outlet of the fuel tank.
The fuel line should run continu-
ously down from fuel tank to car-
buretor.
Other causes. Inspect the starting procedures
carefully in this manual.
The fuel switch (if equipped) is in CLOSE
(OFF) position.
Turn the fuel switch to OPEN (ON)
position.
The throttle is in STOP position. Move the throttle to FAST position.
20 694 - 006 - 12.05.2020