Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Operation
- Before you start the product
- To fill the engine with oil
- To fill fuel
- To adjust the discharge chute and the chute deflector
- To start the engine, manual start
- To start the engine, electric start
- To operate the product
- To stop the product
- To use the throttle control
- To use the fuel switch
- To use the choke control
- To adjust the skid plates
- To prevent freeze-up after use
- To get a good result
- Maintenance
- Introduction
- Maintenance schedule
- To do a general inspection
- To do a check of the oil level
- To replace the engine oil
- To lubricate the product
- Muffler
- To examine the spark plug
- To inspect the augers and the scraper bar
- To replace the auger shear pins
- To replace the impeller shear pins
- To examine the tires
- To clear a clogged discharge chute deflector
- To replace the scraper bar
- Drive belts
- To adjust the tension of the cable for the discharge chute deflector
- To adjust the auger control cable
- To remove the wheels
- To clean the product
- Troubleshooting
- Transportation, storage and disposal
- Technical data
Problem Possible cause Solution
Loss of traction drive/
slowing of drive speed
Loss of snow discharge
or slowing of snow dis-
charge
The belt slips. Adjust the cable. Adjust the belt.
The belt is worn. Check / replace the belt. Adjust the
pulley.
The belt is off the pulley. Check / reinstall the belt. Adjust
the pulley.
The chute deflector is clogged. Clean the chute deflector.
Foreign objects clog the augers. Remove the debris or the foreign
object from the augers.
The shear pin is broken. Replace the broken shear pin.
Excessive snow and ice build up in between
track components.
Remove snow and ice build up
from in between track compo-
nents.
The friction drive wheel is worn. Contact an authorized service cen-
ter.
The friction disc is wet Let the friction disc dry
Failure of auger rotation
after the grip is released
The drive belt is not aligned. Adjust the drive belt.
The discharge deflector is not aligned. Adjust the discharge deflector.
The lights are not on (if
so equipped)
The engine is not running. Start the engine.
The cable connection is loose. Check the cable connections at
the engine and the lights.
The LED is burnt out. Replace the LED light module. In-
dividual LEDs can not be replaced.
The chute rotator is diffi-
cult to move
There is debris in the chute rotator mecha-
nism.
Clean the internal parts of the
chute rotator mechanism.
The cables are kinked or damaged. Make sure that the cables are not
kinked. Replace the cables that
are damaged.
The product turns to one
side
The tire pressure is not equal. Adjust the tire pressure and fill the
tire.
The product drives with only one wheel. Inspect the tire lock pin.
Uneven sled adjustment. Adjust the skid plates and the
sledge.
Uneven skid plates adjustment. Adjust the skid plates and the
sledge.
Transportation, storage and disposal
Transportation and storage
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from
electrical devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel tank before you put the product in
storage for a long period of time. Discard the fuel
at an applicable disposal location
• Safely attach the product during transportation to
prevent damage and accidents.
22 694 - 006 - 12.05.2020