Operation Manual

English - 71
8. MAINTENANCE
8.6 Replacing the blades
There are three blades on Automower
®
, which are
screwed into the blade disc. The blades have four
edges (two edges for 220 AC) to ensure a longer
service life. Two of the edges are equally worn as the
blade disc rotates alternately to the left and
alternately to the right. When the edges (1 and 2)
have become dull, loosen the screw and turn the
knife over so that edges 3 and 4 are facing outwards.
All three blades and screws must be replaced at the
same time to obtain a balanced mowing system.
There are several different types of mower blades to
choose from as accessories, with different features.
Use Husqvarna AB approved blades only, see the
table. Please contact your dealer for more information.
To replace the blades:
1. Set the main switch to the OFF position.
2. Wear protective gloves.
3. Turn Automower
®
upside down.
4. Rotate the skid plate so that its hole aligns with
the screw for the blade.
WARNING
Always use originalblades and
screws when replacing.
Only replacing the blades and
reusing the screw can result in the
screw wearing during mowing and
shearing off. The blades can then be
thrown out and cause serious injury.
Blade type Quantity/Packaging Part number
Stainless steel
(two-toothed, stainless)
9 535 13 87-01
30 535 13 88-01
500 505 12 78-01
Carbon steel
(two-toothed)
9 535 13 87-02
30 535 13 88-02
500 535 12 78-02
Carbon steel
(two-toothed, turnable, extra robust)
9 522 85 16-02
30 522 85 17-02
300 522 85 18-02
1
2
3
4
OFF