Operation Manual

24 - English
3. INSTALLATION
Boundaries for the working area
If a high obstacle, for example a wall or fence,
borders the working area, the boundary wire should
be laid 16" (40 cm) from the obstacle. This will
prevent Automower
®
from colliding with the obstacle
and reduce body wear.
If the working area borders against a small ditch, for
example, a flower bed or a small elevation, e.g. a low
verge (1" - 2")((3 - 5 cm), the boundary wire should
be laid 14" (35 cm) inside the working area. This
prevents the wheels from driving into the ditch or up
onto the verge.
If the working area borders against a flat path or the
like that lies level with the lawn, it is possible to allow
Automower
®
to run a little over the path. The
boundary wire should then be laid 4" (10 cm) from the
edge of the path.
When the working area is divided by a flat slab path
that is level with the lawn, it is possible to allow
Automower
®
to run over the path. It can be an
advantage to lay the boundary wire under the slabs.
The boundary wire can also be laid in the joint
between the slabs.
Note! Automower
®
must never run over a gravel path
or similar material, which can damage the blades.
IMPORTANT INFORMATION
If the working area is adjacent to water
bodies, slopes or precipices, the boundary
wire should be supplemented with a fence or
the like. The height must then be at least 6"
(15 cm). This will prevent Automower
®
from
ending up outside the working area under
any circumstances.
16”
14”
4”
Min.
15cm