Operation Manual

32 - English

3. INSTALLATION

7. Refit the cover on the charging station. Ensure

the three guides on the charging station enter the

right holes in the cover.

3.6 Checking the installation

Check the loop signal by looking to see what

indication the green LED on the charging station is

giving.

• Steady light = the signal is okay.

• Flashing once every other second = break in the

loop and no signal found.

• Flashing twice every other second = weak signal.

This may be due to the boundary wire exceeding

1600 ft (500 m) or that the cable is damaged. If

the mower works, it is not a problem. In case of

operational disturbance, we recommend a Signal

amplifier (522 42 58-01) which is available as an

accessory. This allows a boundary wire of up to

800 metres.

3.7 Linking Automower

to the

charging station

1. Open the control panel cover by pressing the

STOP button.

2. Place Automower

in the charging station.

3. Set the main switch to the ON position.

A start-up sequence begins when Automower

started for the first time. The following is

requested: Language, time format, correct time,

date format, date, and four-digit PIN code. All

combinations except 0000 are permitted.

When you have chosen a PIN code with Automower

placed in the charging station, the mower and

charging station are then linked to each other.

3.8 Installation of the guide wire

The guide wire is an extra wire that is laid from the

charging station, out towards a remote part of the

working area or through a narrow passage and is then

connected to the boundary wire. The same wire used

for the boundary wire is also used for the guide wire.

Up to two guide wires can be installed for Automower

265 ACX. In similarity to the boundary wire, the guide

wire can either be stapled down or buried.

OFF