Operation Manual

3012-1428
English - 33
INSTALLATION
3.8 First start-up and calibration
Before the robotic lawnmower is operated, a start-up
sequence in the robotic lawnmower’s menu must be
carried out as well as an automatic calibration of the
guide signal.
1. Open the control panel hatch by pressing the
STOP button.
2. Set the main switch to position 1.
A start-up sequence begins when the robotic lawnmower
is started for the rst time. The following is requested:
• PIN code from factory. The code is provided on
a special document received by the retailer at
purchase.
• Language.
• Country.
• Date.
• Time.
• Selection and conrmation of personal PIN code.
All combinations except 0000 are permitted.
Place the robotic lawnmower in the charging station and
press START.
The robotic lawnmower will now begin to calibrate the
guide wire. Press START and close the hatch. The
calibration is performed by the robotic lawnmower backing
out of the charging station and running a calibration
process in front of the charging station. When this is
completed, mowing can begin.
IMPORTANT INFORMATION
Use Memo on page 2 to make a note of the
PIN code.
3.9 Test docking with the charging
station
Before using the robotic lawnmower, check that the
robotic lawnmower can follow the guide wire all the way
to the charging station and easily docks with the charging
station.
The test function is found in the robotic lawnmower’s
Installation > Find charging station > Guide > More > Test
guide menu. For more information, See Test settings on
page 55.
If no guide wire is installed the test must be carried out on
the boundary wire, both clockwise and anti-clockwise.
The guide system must rst be calibrated if the above test
is to provide a satisfactory result. See 3.8 First start-up
and calibration on page 33.
OM_1157863-26_HQ 310,315,EN_160229.indd 33 2016-02-29 10:51:55