Operation Manual
3012-1411
English - 52
MENU FUNCTIONS
Area X > More > Test
Testing selected settings can be seen as a natural part of
the installation.
Using the Test function, the robotic lawnmower travels the
farthest distance from the loop allowed by the selected
corridor width.
To test the selected settings:
1. Place the robotic lawnmower in the charging station.
2. Use the down and the right/left arrow keys to
select the area to be tested from the Overview
screen. Press OK.
3. Select More and press OK.
4. Select Test and press OK.
5. Press START and close the display hatch.
6. The robotic lawnmower will now leave the
charging station and begin following the specied
loop toward the remote area. Check that the
robotic lawnmower can follow the loop all along
the required distance.
7. The test is approved when the robotic lawnmower
can follow the selected loop to the required
starting point without any problem.
How to measure the distance to a remote area:
1. Park the robotic lawnmower in the charging
station.
2. In the Area X > How far? menu function, enter a
distance which beyond any doubt exceeds the
real gure. The maximum distance that can be
entered is 500 metres.
3. Select Area X > More > Test and press OK.
4. Press START and close the display hatch.
5. Press STOP at the required position. The distance
is now shown in the display. This gure can now
be saved in Area X > How far?.
Reset
An individual area setting can be reset to the factory
setting using this function. To reset an area setting, select
Area X using the left right arrow keys followed by OK.
Select More and press OK. Select Reset and press OK.
OM_1157863-26_HQ 310,315,EN_160229.indd 52 2016-02-29 10:52:18