Operation Manual

English - 60
MENU FUNCTIONS
Change the name of a prole
The names of the proles can be changed, to make
it easier to remember what settings are stored in the
respective prole.
• Check the prole name to be changed
• Press OK
• Check Rename and press OK.
• Move the cursor withe the arrow keys. Press OK to
select a letter. Press BACK to save the new name.
• The names of the proles will be shown in the menu
Settings - Proles. The name of the selected prole is
also visible on the start page.
Use a Prol
To activate and use a prole, and thus use the saved
settings, the following action must be taken.
• Check the prole to activate.
• Press OK.
• Check Use and press OK.
The robotic lawnmower will now use the settings stored in
the prole.
One Automower
®
for several gardens
The unique connection between the mower and the
charging station is saved in the proles. This enables up
to three charging stations to be connected to the same
robotic lawnmower.
To connect a new charging station to the robotic
lawnmower:
• First save a prole to be used with the original
charging station.
• Then set the mower in the new charging station that
will be connected to the mower.
• Check New loop signal, See 6.5 Security on page 45
• Save a prole for the new charging station.
To use the robotic lawnmower in the original charging
station, the rst prole must now be selected. To use the
robotic lawnmower in the new charging station, that prole
must be selected.
For optimal function, the GPS assisted navigation should
be switched off for all extra installations and only be used
on the main installation. To switch off the GPS assisted
navigation, See 6.8 Installation on page 49.
3012-576
3012-575