Operation Manual

Min.
15cm/6"
3018-046
35 cm/11.8"
> 5 cm/2"
3012-1115
1-5 cm/0.4-2.0"
30 cm/11.8"
3012-1116
10 cm/4"
max 1 cm/0.4"
3012-1117
3012-1118
English - 22
INSTALLATION
Working Area Boundaries
If a high obstacle (5 cm or more), for example a wall
or fence, borders the working area, the boundary wire
should be laid 35 cm from the obstacle. This will prevent
the robotic lawnmower from colliding with the obstacle
and reduce body wear.
About 20 cm around the xed obstacle will not be mown.
If the working area borders on a small ditch, for example a
ower bed, a small elevation or a low kerbstone (1-5 cm),
the boundary wire should be laid 30 cm inside the working
area. This will prevent the wheels going into the ditch or
up onto the kerb, which can cause extensive damage to
the robot lawnmower, especially the front wheels.
About 15 cm of the lawn along the ditch/kerbstone will not
be mown.
If the working area borders on a paving stone path or
similar which is level with the lawn (+/- 1 cm), it is possible
to allow the robotic lawnmower to run a little over the
path. The boundary wire should then be laid 10 cm from
the edge of the path.
All the grass along the side of the path will be cut.
When the working area is divided by a paving stone path
that is level with the lawn, it is possible to allow the robotic
lawnmower to run over the path. It can be an advantage
to lay the boundary wire under the paving stones. The
boundary wire can also be laid in the joint between the
paving stones. Make sure the paving stones are level
with the lawn to avoid unnecessary wear on the robotic
lawnmower.
Note: The robotic lawnmower must never run over gravel,
mulch or similar material which can damage the blades.
IMPORTANT INFORMATION
If the working area is adjacent to bodies of
water, slopes, precipices or a public road,
the boundary wire must be supplemented
with edging or the like. The height must
then be at least 15 cm. This will prevent
the robotic lawnmower from ever ending
up outside the working area.
1157866-26,420,430X,450X,EN_160314.indd 22 2016-03-16 14:42:34