Operation Manual

3018-055

3012-560

135º

90º

3023-015

3023-016

English - 30

INSTALLATION

If the guide wire has to be installed on a steep

slope, it is an advantage to lay the wire at an

angle to the slope. This makes it easier for the

robotic lawnmower to follow the guide wire on the

slope.

Avoid laying the wire at sharp angles. This can

make it difcult for the robotic lawnmower to follow

the guide wire.

6. Run the guide wire to the point on the boundary

wire where the guide wire is to be connected.

Lift up the boundary wire. Cut the boundary wire

using for instance a pair of wire cutters. Connecting

the guide wire is easier if a loop is made on the

boundary wire as described above, see Loop for

connecting the guide wire on page 25.

7. Connect the guide wire to the boundary wire using

a coupler:

Insert the boundary wire into each of the holes

in the coupler. Insert the guide wire in the center

hole in the coupler. Make sure the wires are fully

inserted in the coupler by checking that the ends

are visible through the transparent area on the

opposite side of the coupler.

Use pliers to completely depress the button on the

connector.

It does not matter which holes are used to connect

each wire.

8. Peg down/bury the connector in the lawn.

IMPORTANT INFORMATION

The guide wire may not cross the bound-

ary wire, for instance a boundary wire that

is laid out to an island.

1157866-26,420,430X,450X,EN_160314.indd 30 2016-03-14 16:58:48