Operation Manual
English - 55
MENU FUNCTIONS
Area X > More > Test
Testing selected settings can be seen as a natural part of
the installation.
Using the Test function, the robotic lawnmower travels the
farthest distance from the loop allowed by the selected
corridor width.
To test the selected settings:
1. Place the robotic lawnmower in the charging
station.
2. Use the down and the right/left arrow keys to
select Test under the area to be tested. Press OK.
3. Press START and close the display hatch.
4. The robotic lawnmower will now leave the
charging station and begin following the specied
loop toward the remote area. Check that the
robotic lawnmower can follow the loop all along
the required distance.
5. The test is approved when the robotic lawnmower
can follow the selected loop to the required
starting point without any problem.
How to measure the distance to a remote area:
1. Park the robotic lawnmower in the charging station.
2. In the Area X > How far? menu function, enter
a distance that beyond any doubt exceeds the
actual gure. The maximum distance that can be
entered is 500 meters.
3. Select Area X > More > Test and press OK.
4. Press START and close the display hatch.
5. Press STOP in the desired position and measure
the distance on the display. This value can now be
saved in Area > How long?
Area X > More > Reset
Lawn coverage can be reset to the factory setting using
this function. The factory setting is Area 1 activated with
the following settings:
• How? = Guide 1
• How often? = 20 %
• How far? = 300 m
The same factory setting also applies to Area 2 and Area
3 for Automower® 430X and Automower® 450X.
1157866-26,420,430X,450X,EN_160314.indd 55 2016-03-14 16:59:22