Operation Manual
English - 84
TROUBLE SHOOTING
Message Cause Action
Difcult nding home
The robotic lawnmower has followed
the boundary wire several time without
nding the charging station.
Installation has not been completed correctly.
Incorrect setting of corridor width on boundary wire.
The lawn mower was started on a secondary area
with a main area setting.
Temporary problem
with the server.
Please try again.
In case of persisting problems, get in touch with
your local dealer.
Connection problems
Problem with the Automower®
Connect module
Restart the mower. If the fault persists, action by
and authorized service technician will be required.
Connection settings
restored
Settings for wireless connectivity have
been restored due to an error.
Check and revise settings if necessary.
Weak signal
Weak GPRS signal for Automower®
Connect module
Make sure the mower is not upside down. If the
problem persists, action by and authorized service
technician will be required.
SIM card requires PIN The SIM card must be unlocked.
Make sure the correct SIM PIN has been entered
into the mower's menu (Network > SIM card). In
case of persisting problems, get in touch with your
local dealer.
SIM card locked The SIM card must be replaced. Contact the local dealer.
SIM card not found
Automower® Connect requires a SIM
card to be inserted in the mower.
Contact your local dealer for more information.
Geofence problem
Your Geofence is not working due to
poor (or no) communication with GPS
system.
Contact the local dealer.
SMS could not be sent
Poor GSM coverage
Max. number of SMS reached, max.
10 SMS per month can be sent to the
mower.
No funds left on SIM card.
In case of persisting problems, get in touch with
your local dealer.
9.3 Indicator Lamp in Charging Station
For a fully functional installation, the indicator lamp in the charging station must emit a solid green light. If something
else appears, follow the troubleshooting guide below.
There is more troubleshooting help on www.automower.com. If you still need help with troubleshooting, please contact
the local dealer.
Light Cause Action
Solid green light Good signals No action required
Green ashing light
The signals are good and ECO mode
is activated.
No action required. For more information on ECO
mode, see 6.9 Settings on page 61.
Blue ashing light
The boundary loop is not connected
to the charging station
Check that the boundary wire connector is tted
properly to the charging station. Refer to 3.5
Connecting the Boundary Wire page 27.
Break in the boundary loop
Find out where the break is. Replace the
damaged section of the loop with a new loop wire
and splice using an original coupler.
Red ashing light
Interruption in the charging station's
antenna
Contact the local dealer.
1157866-26,420,430X,450X,EN_160314.indd 84 2016-03-14 17:00:04