Product Manual

wc_tx004127gb_FM10.fm

Operation Walk-Behind Trowels

Continued from the previous page.

Final

assembly

1. Connect the wires (s) from the handle to the wires (t) from the engine. Observe

the following when connecting the engine wires:

■ Honda engines have yellow wires to connect to the handle wires.

■ Wacker Neuson engines have orange wires to connect to the handle wires.

2. Connect the green ground wire from the handle to the green wire from the

engine. If the machine already has the green wire on the engine, discard the

one supplied with the handle. If the machine does not have the green ground

wire, remove the nut (u) from the engine stud, attach the ground wire, and

tighten the nut to 25 Nm (18 ft. lbs.).

Adjusting the

handle

1. Position the adjustable handle by loosening the lever (v) and adjusting the

handle up or down to suit the operator.

2. Tighten the lever to secure the handle in position.

Final check

1. Start the engine and check the idle RPM. The specification is 1450±100 RPM.

2. Quickly move the handle counterclockwise to test the engine control module

function. The engine should stop.

CAUTION

► If the engine does not stop automatically, shut down the machine manually.

Have an authorized dealer service the machine before using.

NOTICE: When storing the machine, do not fully pitch the trowel blades and fold

the handle. The pitch control cable and possibly the pitch assembly may be

damaged. Flatten the trowel blades before folding the handle.

wc_gr014684