Product Manual

wc_tx004127gb_FM10.fm

Walk-Behind Trowels Operation

Continued from the previous page.

9. Attach the cable nut to the pitch control cable and adjust the cable nut so the

pitch control cable is snug but the trowel blades lay flat (0° pitch).

Installing the

throttle cable

1. Move the throttle to the idle position as shown.

2. Feed the throttle cable through the clamp (o) on the engine’s recoil cover (p).

3. Connect the throttle cable to the engine throttle bracket by placing the special

bend through the hole in the throttle plate (q).

Note: If necessary for easier access, remove the air cleaner assembly.

4. Hold the engine throttle lever in the idle position and clamp the cable into the

throttle casing bracket (r).

5. Install the air cleaner assembly if it was removed.

This procedure continues on the next page.

wc_gr014678

wc_gr014682

wc_gr014683