Product Manual

wc_tx004127gb_FM10.fm

Walk-Behind Trowels Operation

Continued from the previous page.

Stopping the

machine

9. Move the throttle to the idle position (a1).

10.Push the stop button (b).

11.Turn the ON/OFF switch to the OFF position (c2).

12.Close the fuel valve by moving the lever to the left (k2).

13.Allow the machine to cool.

14.Clean the trowel after each use by flushing with water to remove concrete

splatter. Do not use a high pressure washer to clean electrical equipment.

Note: Do not attempt to clean, service or perform adjustments on the trowel while it

is running.

4.13 Emergency Shutdown Procedure

Procedure

If a breakdown or accident occurs while the machine is operating, follow the

procedure below:

1. Stop the engine.

2. Close the fuel valve.

3. Remove the machine from the job site using correct lifting techniques.

4. Clean concrete from the blades and the machine.

5. Contact the rental yard or machine owner for further instructions.

WARNING

Personal injury hazard. Touching a hot motor could burn the operator.

► Allow the motor to cool before cleaning or servicing the machine.