Operation Manual

8:10
Embroidery Stitch-Out
Function Buttons in Embroidery
Stitch-Out
Speed + and -
Touch Speed + or Speed - to increase or decrease the
sewing/embroidery speed. When you are not embroidering,
touch Speed and a pop-up message on the screen will
indicate the speed set ting. You can set the speed by
touching the slider bar in the pop-up message. If you
change the speed set ting while sewing no pop-up message
will appear.
Each hoop size has a pre-set embroidery speed. When
sewing with metallic threads, or when sewing on delicate
fabrics, embroidery speed may have to be lowered.
STOP
Touch STOP to eliminate stops for color changes to create
one-color embroidery.
FIX
Touch FIX to baste an outline of the embroidery design
area or to baste the fabric to the stabilizer.
Sensor Foot Down and Pivot
The presser foot is lowered automatically when you start
sewing/embroidering.
In Embroidery Mode, touch the Sensor Foot Down button
to lower the presser foot into the Embroidery “Á oat”
position.
Sensor Foot Up and Extra Lift
Touch the Sensor Foot Up and Extra Lift to lift the presser
foot to Up position. Touch once more and the presser foot
will raise to Extra Lift, to make it easier to insert or remove
the hoop.
Speed + and -
Stop
FIX
Sensor Foot Down and
Pivot
Sensor Foot Up and
Extra Lift
Start/Stop
Selective Thread Cutter
Needle Up/Down / Trim Position
Stitch Re-Start/
Bobbin Access
Selective Thread Cutter
The Selective Thread Cutter automatically cuts the threads
and raises the presser foot. At the end of a color block the
top thread only is cut. When the design is À nished, both
top and bobbin threads are cut automatically.
Start/Stop
Touch this button to start and stop the machine sewing or
embroidering without the foot control. Touch START/
STOP to begin and touch again to stop.
Needle Stop Up/Down / Trim Position
If you touch the Needle Stop Up/Down in Embroidery
mode, the hoop will move forward, toward you, for easy
thread trimming.
Stitch Re-Start / Bobbin Access
In Embroidery Stitch-Out; touch Stitch Re-Start to move
the hoop position back for easy bobbin access. When
you touch the Stitch Re-Start button again, the hoop will
move back into position and embroidery will resume at the
current stitch position.