Operation Manual

3:10
Ultimate Interactive Screen
Sound Settings
You can change the Sound Settings on your machine to
alert you at a variety of situations. Select which sound
function you want to change. Then select the sound you
want to play by touching the icon. You will be able to hear
a preview of the sound when you touch the sound icon.
Each alert function can have a different sound. Close the
pop-up with the OK icon.
User-DeÀ ned Sound
You can use your own sound À les in the machine. Touch
the sound setting you wish to alter. At the bottom of the
list of sounds you will À nd the User-DeÀ ned Sound.
If you want to change your User-DeÀ ned Sound, Touch &
Hold the User-DeÀ ned Sound icon and you will enter My
Files and be able to change the sound.
Note: If you touch this icon for the À rst time it will open My Files.
Find your sound À le and touch the OK icon. The name of the loaded
sound À le is shown next to the icon.
The sound length for icon acknowledgement, button/icon
disabled alert for warning or attention pop-up messages
is maximum of 5 seconds. For Start up and Embroidery
Finished, the maximum sound length is 30 seconds.
Note: You can only play PCM encoded WAVE-À les. For optimal
result the À le should be 8-bit mono. Your machine will not support
compressed sound À les. Always save your sound À les in the My Files
folder on your machine.
Audio Repeat
When active, the signal for some warning alerts or
attention pop-up messages is repeated in intervals until it is
cancelled.
Volume
You can change the volume using the slider bar. All sounds
settings will be affected if the volume setting is changed