Operation Manual

3:13
Ultimate Interactive Screen
Speed + and -
STOP
FIX
Sensor Foot Down and
Pivot
Sensor Foot Up and
Extra Lift
Start/Stop
Selective Thread Cutter
Needle Stop Up/Down
Stitch Re-Start
Function Buttons
Speed + and -
All stitches in your machine have a pre-set, recommended
sewing speed. When you select a stitch, your machine
automatically sets the best sewing speed for that stitch.
Touch Speed+ or Speed - to increase or decrease the
maximum allowed sewing speed. When not sewing, touch
Speed and a pop-up message on the screen will indicate the
speed set ting. You can set the speed by touching the slider
in the pop-up message. If you change the speed set ting
while sewing no pop-up message will appear.
Start/Stop
Touch this button to start and stop the machine sewing
or embroidering without using the foot control. Touch
START/STOP to begin and touch again to stop.
Selective Thread Cutter
Sewing Mode
Touch the Selective Thread Cutter button and your machine
cuts the top and bobbin threads, raises the presser foot and
the needle, and activates the FIX function for the next start.
To cut threads at the end of a stitch or stitch program, touch
Selective Thread Cutter while sewing. The button starts to
Á ash, indicating that a cut is requested. When the stitch or
stitch program is completed, the upper thread and bobbin
thread will be cut. The Selective Thread Cutter function can
be programmed, see Program chapter.
Note: Your machine cuts the threads automatically after certain
stitches such as completing a Sensor One Step Buttonhole. Automatic
Selective Thread Cutter can be cancelled in the SET Menu, see page
3-9.
Embroidery Stitch-Out
The Selective Thread Cutter cuts the threads and raises
presser foot. When the design is À nished, both top and
bobbin threads are cut automatically.
Needle Stop Up/Down
Sewing Mode
Touch the Needle Stop Up/Down to move the needle up
or down. The set ting of the needle stop po si tion is changed
at the same time. This function will also set the needle
position up or down when you stop sewing. You can also
tap the foot control to raise or lower needle once you stop
sewing.
Embroidery Stitch-Out
The machine will move the hoop forward, towards you, for
easy thread trimming.
Stitch Re-Start
Sewing Mode
When you stop sewing in the middle of a stitch, touch
Stitch Re-Start to begin sewing at the beginning of the
stitch. The stitch or stitch program will remember any
special settings you made.
Embroidery Stitch-Out
Touch Stitch Re-Start to move the hoop position back for
easy bobbin access. When you touch the Stitch Re-Start
button again, the machine will move the hoop back into
position at the current stitch.