Phau Ntawv Qhia

• Sparks can occur when you operate the product.
Make sure that you have a fire extinguisher near.
Safety devices on the product
WARNING: Read the warning
instructions that follow before you use the
product.
• Do not use a product with defective safety devices.
• Do a check of the safety devices regularly. If the
safety devices are defective, speak to your
Husqvarna service agent.
To do a check of the carriage lock
1. Turn the knob to lock the drill motor carriage.
2. Feel by hand that the drill motor carriage is locked to
the drill column.
Safety instructions for maintenance
WARNING: Read the warning
instructions that follow before you use the
product. Save all warnings and instructions
for future operations.
• Stop the drill motor, disconnect the power supply
and remove the drill motor before maintenance of
the product.
• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
• Do not use a product that is defective. Do the safety
checks, maintenance and the servicing as given in
this manual. All other maintenance work must be
done by an approved servicing dealer.
• Do the maintenance to make sure that the product
operates correctly. Refer to Daily maintenance on
page 12
.
Assembly
Introduction
WARNING: Read and understand the
safety chapter before you assemble the
product.
To install the wheel kit
The wheel kit is not supplied for all models.
• Attach the wheel kit to the bracket at the rear end of
the bottom plate and tighten the screws.
To attach a drill motor (DS150)
WARNING: Disconnect the drill motor
from the power supply.
1. Remove the drill bit from the drill motor.
2. Lock the carriage lock.
1341 - 003 - 27.10.2021 5