Phau Ntawv Qhia

3. Put the drill spindle through the collar in the drill
motor carriage.
4. Tighten the screw with the feed lever.
To attach a drill motor (DS250)
WARNING: Disconnect the drill motor
from the power supply.
1. Remove the drill bit from the drill motor.
2. Lock the carriage lock.
3. Attach the drill motor in the lock clamp on the drill
motor carriage.
4. Push the drill motor fully down to the bottom of the
lock clamp (A).
C
A
B
5. Tighten the lock clamp with the lever (B).
6. If you install the drill motor DM240, also tighten the
lock screw (C).
Note: The lock screw is only used together with
the drill motor DM240.
Installation
Procedures for installation
There are 3 procedures that can be used to install the
product before a drill operation:
• With an expander bolt.
• With a vacuum plate.
• With an all thread rod, a washer and a locknut.
To install the product with an expander bolt
WARNING: To install the product to a
ceiling or a wall puts much strain on the
surface. For operation in ceilings and walls,
use only an expander bolt or anchor screw
that is applicable for the strain.
1. Drill a hole for the expander bolt.
6 1341 - 003 - 27.10.2021