Phau Ntawv Qhia
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Installation
- Operation
- Maintenance
- Transportation and storage
- Technical data
- Accessories
- Service
- Contenido
- Introducción
- Seguridad
- Montaje
- Instalación
- Funcionamiento
- Mantenimiento
- Transporte y almacenamiento
- Datos técnicos
- Accesorios
- Servicio
- Table des matières
- Introduction
- Sécurité
- Montage
- Installation
- Fonctionnement
- Entretien
- Transport et entreposage
- Données techniques
- Accessoires
- Service
a) For DS150: Drill the hole at a distance (A) of 293
mm/11.5 in. from the center of the hole that you
will drill.
A
b) For DS250: Drill the hole at a distance (A) of 300
mm/11.8 in. from the center of the hole that you
will drill.
A
Note: The distance is for drill motor DM220
installed on the quick mounting plate. If the drill
motor is installed with a collar, the distance is
320 mm/12.6 in.
2. Attach the bottom plate with an expander bolt.
3. Make sure that the expander bolt is tightened
correctly.
1341 - 003 - 27.10.2021
7