GB Operator´s manual EDGER FR Manuel d'utilisation ACCESSOIRE ES Manual de instrucciones SUPLEMENTO Please read these instructions carefully and make sure you understand them before using the machine. ATTACHMENT EA 850 TRANCHE-BORDURE CORTABORDES Lire attentivement et bien assimiler le manuel d’utilisation avant d'utiliser la machine. EA 850 EA 850 Lea detenidamente el manual de instrucciones y asegúrese de entender su contenido antes de utilizar la máquina.
CONTENTS Contents CONTENTS Contents ...................................................................... Note the following before starting: ................................ WHAT IS WHAT? What is what on the edger attachment? ...................... SAFETY INSTRUCTIONS Machine′s safety equipment ........................................ General safety precautions .......................................... General working instructions ....................................... Basic working techniques .........
WHAT IS WHAT? 2 4 3 5 1 10 4 1 6 7 8 9 What is what on the edger attachment? 1 Cutter 6 Locking knob 2 Grease filler cap, bevel gear 7 Drive disc 3 Bevel gear 8 Support flange 4 Blade guard 9 Locking nut 5 Shaft 10 Operator′s manual English –3
SAFETY INSTRUCTIONS Machine′s safety equipment Cutting equipment This section describes the machine′s safety equipment, its purpose, and how checks and maintenance should be carried out to ensure that it operates correctly. See the ”What is what?” section to locate where this equipment is positioned on your machine. The cutter is designed and manufactured to withstand the loads that edging of a lawn involves.
SAFETY INSTRUCTIONS Personal protection • Check that the cutter and cutter guard are correctly secured. • When adjusting the carburettor make sure the cutter is held against the ground and that no-one is in the immediate vicinity. • Make sure the cutter always stops when the engine is idling. • Make sure that the handle and safety features are in good working order. Never use a machine that lacks a part or has been modified outside its specifications.
SAFETY INSTRUCTIONS Basic working techniques ! Safety instructions while working • Always ensure you have a safe and stable working position. • Always use both hands to hold the machine. Hold the machine at the side of your body. ! WARNING! Sometimes grass or stones can get trapped in the cutter guard and cutter. Always stop the engine before cleaning. WARNING! Watch out for thrown objects. Always wear approved eye protection. Never lean over the cutting attachment guard. Stones, rubbish, etc.
ASSEMBLY Fitting the bevel gear Fitting the cutter Fit the bevel gear on the shaft. Turn the cutter so that the shaft engages in the bevel gear. Fit the cutter as follows: Position the bevel gear so that the slot aligns with the line on the shaft. 1 Fit the drive disc (A) on the output shaft. Make sure that the edge that engages in the hole in the cutter is facing outwards.
STARTING AND STOPPING Starting and stopping Check before starting • For safety reasons follow these recommendations! • Check that the support flange is not cracked due to fatigue or due to being tightened too much. Discard the support flange if it is cracked. • Ensure the locking nut has not lost its captive force. The nut lock should have a locking force of at least 1.5 Nm. The tightening torque of the locking nut should be 35-50 Nm.
MAINTENANCE Bevel gear Maintenance schedule Below you will find some general maintenance instructions. If you need further information please contact your service workshop. The bevel gear is filled with the right quantity of grease at the factory. However, before using the machine you should check that the bevel gear is filled three-quarters full with grease. Use HUSQVARNA special grease. The grease in the bevel gear does not normally need to be changed except if repairs are carried out.
50309-20 ´®z+R>|¶0z¨ ´®z+R>|¶0z¨ 2006-10-03