Operators Manual

English – 11
2.2 CORD SETS AND CONNECTION PLUGS
The following are descriptions of the controls on the power panel.Your generator has sock-
ets to power your products with circuit breakers to protect the voltage ow.
1. Engine Switch: Used to start and stop the engine.
For recoil start. For electric start.
2. Circuit Breakers: The circuit breaker protects the generator from overloading. The rat-
ing of the breaker and the load it protects are marked near the breaker. Should any of the
circuit breakers trip,the generator will stop the electricity output. If this happens, unplug all
loads from the generator. Allow the generator to cool down. Then, press the tripped circuit
breaker, restart the engine, and re-attach loads.
3. Grounding Terminal: Prior to each use, set up the ground wire (not included) connec-
tion to the grounding terminal to properly ground the generator.
4. 12 V DC Terminal: 12V DC terminal provides a power source for 12 volt DC items.
5. V.F.T Meter
V means voltage of running.
F means frequency of running.
T means accumulative running time of the generator.
Means that the IK code of this meter is IK06, the surface of this meter was subject to one impact
by a smooth steel sphere with a mass 500 g ± 25 g and with a diameter of approximately 50 mm.
Impact energy level is 1J, Height 200 mm.
I
O
ON
OFF
DC12V/8.3A
V
F
T